CHOCOLATE TRUFFLES II

Classic chocolate confectionery

These are as good!or better!than anything you can buy in a store.

Ingredients

(makes 10 dozen)

Procedure

  1. Chop the chocolate. Melt together with the butter over simmering water. Stir continuously with a rubber spatula. Don't let water get into the chocolate.
  2. Warm the Cointreau to the same temperature as the chocolate. Slowly blend the Cointreau into the chocolate (still over the water). Stir continuously. Do this slowly (as if you were making hollandaise). Using an electric mixer, beat the mixture until cool and somewhat thickened. (Takes about 5 minutes; you'll need a good mixer.)
  3. Line a large baking sheet (30 x 40 cm) with wax paper. Pour in the truffle mix. (This will fill the pan.) Chill in the refrigerator until solid (several hours).
  4. Use a pizza cutter to cut the stuff into strips (peel off the wax paper first), then into squares. Take each one, mash it in your palm, and roll in cocoa. Chill some more.

Notes

I recommend Merckens Yucatan or Lindt Extra Bittersweet for the dark coating chocolate. In place of the Cointreau, try substituting other liqueurs (Chambord, Amaretto, Kahlua) and coatings (chopped roasted almonds, finely chopped candied orange peel, coffee beans run through a nutmeg grinder, etc.)

Truffles rolled in cocoa are "classic"!here are some rough and ready instructions for coating anything with chocolate, abstracted from Making Chocolates by Alec Leaver, published in 1975 by Weathervane Books by arrangement with Michael Joseph Ltd. (The book is out of print.)

Melt some chocolate over hot water, let it cool slowly until it just thickens 26-28\(deC) Now warm the chocolate gently and slowly until it thins slightly. The temperature should be above 29C but below 32C This maximum working temperature is absolutely crucial. The temperature of the room you work in should not exceed 21C

Pre-bottom all centers!that is, smear a little couverature on what will be the bottom of the center with the back of a spoon and place it, bottom side up, on a plate. This lets you check that the couverature is properly tempered.

After the bases have set and hardened a little, stir the couverature thoroughly, trying not to get too many air-bubbles in. Drop a center into the couverature, bottom down and, with an ordinary fork, slightly warmed, push it down to submerge it fully. Immediately, pick it out with the fork, tap the fork on the side of the bowl in order to settle the chocolate, and wipe any excess from underneath the fork. Transfer the center to a sheet of wax paper. Stir the couverature after depositing each center to keep it well mixed.

The basis of the truffle centre is ganache paste, a mixture of melted chocolate and warm cream well blended and cooled until it hardens. Orange, honey, peppermint, rum or vanilla can be added to give flavor, but it is important that the final mixture should be hard enough to be moulded to shape and be capable of standing up to being coated with chocolate. The texture of ganache paste depends upon the kinds of cream and chocolate and the proportions in which they are used. Plain chocolate is harder than milk chocolate, so more cream can be added to it. Single cream is thinner than double so must be used in smaller quantities. Incorporating cream or other liquids fulfills two functions: it softens the chocolate and it gives flavor.

After the centre has been made and moulded to shape, it is coated with chocolate to seal it and help to keep it moist. It is then rolled in a final decorative coating, and this can cocoa sweetened with a little icing sugar, or chopped mixed nuts.

Rating


Difficulty: moderate for classic truffles, quite difficult for coated centers.
Time: most of a day.
Precision: measure carefully.

Contributor

 
Martin Minow 
Digital Equipment Corporation, Ultrix Engineering Group, Merrimac, NH 
decvax!minow
Recipe last modified: 19 Dec 85

Original header

From: minow@decvax (Martin Minow)
Newsgroups: mod.recipes
Subject: RECIPE: Chocolate Truffles II
Date: 28 Feb 86 05:12:13 GMT
Organization: DEC - ULTRIX Engineering Group
Approved: reid@glacier.ARPA


 Copyright (C) 1986 USENET Community Trust
Permission to copy without fee all or part of this material is granted
provided that the copies are not made or distributed for direct commercial
advantage, the USENET copyright notice and the title of the newsgroup and
its date appear, and notice is given that copying is by permission of
the USENET Community Trust or the original contributor.